3M Car Lantern Set with 3 Sandpaper Sponge No. 800,1000,3000 Lens coating and 3 inch keyboard or spiral core

Front and end of the headlights Designed for removing general marks and yellow stains Helps the white light to increase the efficiency of the brightness. Looking at the road safely Easy to use 4 steps Used with ordinary drills around 1200-1600 rounds, helping to save time And expenses, which can be done by yourself, 4 steps, which can be done by yourself without having a special device or hiring an expert Just a general drill in the house Help save money Can be used with headlights, rear lights, navigation lights that require a drill around 1200-1600 microfiber fabric And Space cans, sandpaper, number 800, 5, sandpaper, three -sided number 1000, 1 sheet, number 3000, 1 sheet, sponge, 3 "(for the core of the drill or spiral in 16 mm), 2 sachets For 2 cleaning lamps And the tape around the lens to scrub 1. Put the keyboard and drill Use sandpaper number 800 before scrubbing-middle to remove yellow stains and various marks. When scrubbing the paper out of the sheet Close the drill Then change to a new sheet Continue until the end of various marks. 2. Next Use sandpaper number 1000 to remove various marks. From step 2, polished-middle Always injected with water (Cannot be scrubbed) not too much After this step, the fire should be whiter. 3. Use the sandpaper of the 3000 threshold. (Can not be scrubbed) lightly-in the middle, continuous, the light will be much clearer Then wipe with a microfiber cloth Check the work if there are still marks. Repeat 4. Coated with a sheet Before coating, it must be confident that the workpiece is thoroughly, to the end of the sandpaper polishing process. By observing from the surface of the headlights must be consistent Which will be a gloomy skin